无线网卡ra0配置命令.docVIP

无线网卡ra0配置命令iwpriv=================This is detailed explanation of each parameters for iwpriv.Before reading this document, make sure you already read README.USAGE: iwpriv ra0 commands valNOTE: Wireless Extension Private Handlerswhere[commands] [val] {range} wsc_conf_mode {0, 1, 2} ::Set WPS conf mode 0: WPS Disabled 1: Enrollee 2: Registrarwsc_mode {1, 2} ::PIN or PBC 1: PIN 2: PBCwsc_pin ~ ::Set Enrollees PIN Codewsc_ssid {0~z, 1~32 ascii characters} ::Set WPS AP SSIDwsc_start NULL ::Trigger RT2860 STA driver to do WPS processwsc_stop NULL ::Stop WPS processwsc_gen_pincode NULL ::Generate new PIN codewsc_cred_count {1 ~ 8} ::Set count of WPS credentialwsc_cred_ssid {idx ssid_str} ::Set SSID into credtentail[idx] idx: 0 ~ 7 ssid_str: 0~z, 1~32 ascii characterswsc_cred_auth {idx auth_str} ::Set AuthMode into credtentail[idx] idx: 0 ~ 7 auth_str: OPEN, WPAPSK, WPA2PSK, SHARED, WPA, WPA2wsc_cred_encr {idx encr_str} ::Set EncrypType into credtentail[idx] idx: 0 ~ 7 encr_str: NONE, WEP, TKIP, AESwsc_cred_keyIdx {idx key_index} ::Set Key Index into credtentail[idx] idx: 0 ~ 7 key_index: 1 ~ 4wsc_cred_key {idx key} ::Set Key into credtentail[idx] idx: 0 ~ 7 key: ASCII string (wep_key_len(=5,13), passphrase_len(=8~63)) OR Hex string (wep_key_len(=10,26), passphrase_len(=64))wsc_cred_mac {idx mac_str} ::Set APs MAC into credtentail[idx] idx: 0 ~ 7 mac_str: xx:xx:xx:xx:xx:xxwsc_conn_by_idx {0 ~ 7} ::Connect AP by credential indexwsc_auto_conn {0, 1} ::Set driver to re-connecting to AP or not after registration. 0: Disabled, driver wont re-connect to AP with new configurations. 1: Enabled, driver will re-connect to AP with new configurations.wsc_ap_band {0, 1, 2} ::Set prefer band to do WPS with du