The alowable deviation of the unit.docVIP

The allowable deviation of the unit (mm) Project allowable deviation Unit length of 20 m or less splice length single span 10.0 mm Multi-span continuous + / - 5.0 Unit length 20 m splice length single span 20.0 mm Multi-span continuous + / - 10.0 3), the allowable deviation of steel grid structure installation (mm) Projects allow deviation test methods Vertical and horizontal length L / 2000, and should not be greater than 30.0 steel measurement - L / 2000, and should not be less than 30.0 Migration L / 3000 bearing center, and should not be greater than 30.0 steel and theodolite real side Surrounding supporting rack adjacent bearing elevation difference L / 400, and should not be greater than 15.0 steel and level measurement Bearing the biggest difference of 30.0 Multipoint bearing rack adjacent bearing elevation difference L1/800, and should not be greater than 30.0 Note: 1, L for vertical, horizontal length; 2, L1 for adjacent bearing spacing. 6.5.5 testing project 1, raw material The mechanical properties and chemical composition of steel products with existing national standards and design requirements, check the quality qualification book and quality inspection reports, etc. 2, welding material, Welding material varieties, properties of products with existing national standards and design requirements, check the quality of books and qualified quality inspection reports, etc. 3, high strength bolt High strength bolts should accord with the requirement of national standard, should check the quality of the product qualification certificate, Chinese logo and inspection reports, etc.; High strength bolt hardness tester was used to test surface hardness, hardness should be consistent with the space truss structure engineering quality inspection evaluation standard of specific requirements. 4, bolts ball maximum thread hole Bolt ball to maximum tensile strength of the screw hole, with the bolt hole thread is cut the ultimate bearing capacity