ICND04_Operating and Configuring a Cisco IOS Device.ppt

Objectives On completion of this chapter, you will be able to perform the following tasks: Start up the Catalyst switch and Cisco router and observe the boot up processes Provide an initial configuration for the switch and perform the router’s initial setup configuration Enable and identify the command modes in each network device Objectives (cont.) Use the various help and command line-editing features of each device’s user interface Show and recognize fundamental technical details about each network device Cisco Internetwork Operating System (IOS) Software Network Device Configuration Configuration sets up the device with: Network policy of the functions required Protocol addressing and parameter settings Options for administration and management Catalyst switch memory has initial configuration with default settings Cisco router will prompt for initial configuration if there is no configuration in memory An Overview of Cisco Device Startup External Configuration Sources Cisco IOS User Interface Fundamentals Cisco IOS Software EXEC Cisco IOS Software EXEC (cont.) Initial Start up of the Catalyst Switch Checking Switch LED Indicators Port LEDs during Switch POST 1. At the start, all port LEDs are green. 2. Each LED turns off after its test completes. 3. If a test fails, its LED turns amber. 4. System LED turns amber if any test fails. 5. If no test fails, POST completes. 6. On POST completion, LEDs blink  then turn off. Initial Bootup Output from the Switch Logging into the Switch and Entering the Enable Password Switch Command Line Help Facilities Showing Switch Initial Startup Status Switch show version Command Switch show running-configuration Command Switch show interfaces Command Configuring Switch Identification Initial Start Up of the Cisco Router BootUp Output from the Router Setup: The Initial Configuration Dialog Setup Interface Summary Setup Global Parameters Setup Global Parameters (cont.) Setup Interface Parameters Setup Script