040 Starting a Switch.pptVIP

Starting a Switch Initial Startup of the Catalyst Switch Catalyst 2950 Switch LED Indicators Port LEDs During Switch POST 1. At the start, all port LEDs are green. 2. Each LED turns off after its test completes. 3. If a test fails, its LED turns amber. 4. System LED turns amber if any test fails. 5. If no test fails, POST completes. 6. On POST completion, LEDs blink,  then turn off. Initial Bootup Output from the Catalyst 2950 Switch Logging In to the Switch and Entering the Enable Password Switch Command-Line Help Facilities Configuring the Switch Configuring Switch Identification Configuring the Switch IP Address Switch show version Command Switch show running-configuration Command Switch show interfaces Command Showing the Switch IP Address END CCNA+ @2006 Steve6307 Stanley WY. All rights reserved. 王琳琳 CCNA+ @2006 Steve6307 Stanley WY. All rights reserved. System startup routines initiate switch software. Initial startup uses default configuration parameters. --- System Configuration Dialog --- At any point you may enter a question mark ? for help. Use ctrl-c to abort configuration dialog at any prompt. Default settings are in square brackets [ ]. Continue with configuration dialog? [yes/no]: yes Enter IP address: ip_address Enter IP netmask: ip_netmask Would you like to enter a default gateway address? [yes]: yes IP address of the default gateway: ip_address Enter a host name: host_name Enter enable secret: secret_password Would you like to configure a Telnet password? [yes] yes Enter Telnet password: telnet_password Would you like to enable as a cluster command switch? no Enter cluster name: cls_name 虽然cisco catalyst系列交换机,在初始化时,没有发现用户配置文件时,会载入Default Settings(默认配置),同时系统也会进入System Configuration Diaglog(setup 模式)要求管理员进行交换机初始化.但不会影响交换机的正常工作。 Context-Sensitive Help Console Error Messages Identifies problems with any switch commands that are incorrectly entered so that you can alter or correct them Allows recall of long or complex commands or entries for ree