解读如何运用设计软件进行建筑结构设计.docVIP

解读如何运用设计软件进行建筑结构设计 Read how to use design software architecture design 如今,在建筑布局描绘中,核算机辅助描绘现已十分遍及,怎么正确运用描绘软件进行布局描绘,以满意现行国家标准的需求,是每个描绘人员都十分关怀的疑问。下面以SATWE为例进行评论。完结全体参数的正确设置，描绘核算开端曾经,描绘人员大概首要对软件参数进行正确设置。在一个工程中其间一些参数是关系到全体核算结果的,只要正确设置,才干保证其核算结果的正确性。这些参数包含振型组合数、最大地震力效果方向和布局根本周期等。 　 Now, in the architectural layout, accounting machine auxiliary has highly throughout, depict how to correctly use software for layout, in order to satisfied with the current national standard requirement, is that every staff is very caring questions. The following comment in SATWE, for example. Beginning end all the parameters set up correctly, describe accounting once, depicting people probably leading to software parameters are set correctly. In a project during which some of the parameters is related to the calculation results, as long as the correct Settings, talents to ensure the correctness of the calculation results. These parameters include number of modal combination, effect of maximum earthquake force direction and layout fundamental cycle, etc. 振型组合数是软件在做抗震核算时思考振型的数量。该值取值太小不能正确反映布局的实际状况,使核算结果失真;取值太大,不只浪费时间,还可能使核算结果发作畸变。一般状况是振型数的多少与布局层数及布局自在度有关,当布局层数较多或布局层刚度骤变较大时,振型数应当获得多些。 Number of modal combination is doing aseismatic calculation software when thinking about the number of vibration mode. Value the value is too small can not correctly reflect the actual status of the layout, make the distortion of accounting results; Value is too large, not only a waste of time, may also make accounting distortion results attack. General how much is the number of modes related to layout layer number and the layout of comfortable degree, when many layers of layout or layout layer stiffness change is bigger, the vibration mode number should be given more. 振型组合数能否取值合理,能够看软件核算书中的x,y向的有用质量系数能否大于0.9。具体操作是,首要依据工程实际状况及描绘经历预设一个振型数核算后调查有用质量系数能否大于0.9,若小于0.9,可逐渐加大振型个数,直到x,y两个方向的有用质量系数都大于0.9停止。有必要指出的是,布局的振型组合数并不是越大越好,其最大值不能超过布局得总自在度数。 Modal combination number value can be reasonable, can see the