吹瓶回机操作,如 (修复的).docxVIP

吹瓶机操作operating blowing machine 一、.开机前注意事项：cautions before start machine1、机器在开始加温时，首先打开机筒冷却水，加温时间是当各段温达到设定工艺温度后，保温30分钟才能挤料，在加温期间不能提高设定温度来加快加温时间，因为这样做表面温度是达到了而塑料的内部温度实际还没有达到工艺温度的（塑料没有完全融化），这个时候挤料会使电机和齿轮箱的负荷，导致电机和齿转箱容易损坏；还会导致模头各锁紧部位漏料；记录每次加温的时间和各段的温升情况，发现温度不对及时向班长或机修人员报修，并登记报修记录；检查压缩空气的气压能不能达到0.6Mpa≤气压≥0.8Mpa。检查如部件的螺丝和螺母是否松动，如果有松动的要打紧，必要时可以报机修人员检查和固定，检查气动三联件，油雾器油量如果少了要及时补充。First turn on the cooling water of the barrel before the machine heats. When all temperature reaches the setting, need hold time for 30 minutes before extrusion. It is forbidden that turn up setting temperature to accelerate heating time. Because the surface temperature is enough but the inner temperature of plastic doesn’t reach technique time (the plastic no fusing completely), extrusion will increase motor and gear wheel box load and damage motor and gear wheel box. At the same time cause die head leakage. Record heating time and temperature rise condition of all stages. When find the temperature is abnormal, submit to superior in time and record. Check if the compressed air pressure is between 0.6Mpa and 0.8Mpa. Check if the screw and nut loosen, if loosen, tighten, submit to superior if necessary. Check pneumatic three series device, Check if the oil in oil mist device is enough, if it is lack, replenish in time.2、开机的条件，如果要左架上架条件是：左插笔回笔止接近开关亮、左开模止接近开关亮和右架下止接近开关亮；如果右架上架条件是：右插笔回笔止接近开关亮、右开模接近开关亮和左架下止接近开关亮；Starting requirement: left carrier up requirement: left pin up and sensor light, left mold open and sensor light and right carrier down and sensor light. Right carrier up requirement: right pin up and sensor light, right mold open and sensor light and leftcarrier down and sensor light.走全自动时下架条件是合模止开关要亮和上面所需的条件才能动作，还要保证插笔对正和垂直；旋刀架必需调水平，这样才能把瓶口切平，还有旋刀要在同一条线上，还要在旋刀杆上安装上平垫和弹垫，这样就可以不用锁太紧，也可以方便和轻松的调节刀的角度，还要保证脱瓶套的完整，不能用手去拉瓶子。When autorun, carrier down requirement: mold close, sensor light and above-mentioned requirement. At the same time assure pin right and vertical. The cutter carrier must be horizon