ANSYS 单元拉伸建模课件.pptVIP

July 30, 1999 Workshop 9ASelect LogicSilo 9A. Select LogicSilo Description Using select logic, assign solid model attributes to the silo model below and then mesh it. The model consists of both shells and beams. 9A. Select LogicSilo Element types: SHELL63 (TYPE 1) throughout cylinder and cone areas. BEAM4 (TYPE 2) stiffeners for all lines in cone. 9A. Select LogicSilo Materials: Concrete (MAT 2) for cylinder areas. Steel (MAT 1) for cone areas and stiffeners. 9A. Select LogicSilo Real Constants: Shell thickness = 1.0 (REAL 1) for cylinder. Shell thickness = 0.375 (REAL 2) for upper part of cone. Shell thickness = 0.25 (REAL 3) for lower part of cone. Beam constants (REAL 4) for stiffeners. 9A. Select LogicSilo 1. Enter ANSYS in the working directory specified by your instructor using “silo” as the jobname. 2. Resume the “silo.db1” database file: Utility Menu File Resume from … Select the “silo.db1” database file, then [OK] Or issue: RESUME,silo,db1 3. Bring up the “Select Entities” menu and select the cylinder areas: Utility Menu Select Entities … Select “Areas”, “By Location”, “Z coordinates” Min,Max = 0,120 [Apply] Or issue: ASEL,S,LOC,Z,0,120 9A. Select LogicSilo 4. Assign solid model attributes to the cylinder areas: Main Menu Preprocessor MeshTool … Select “Areas” under Element Attributes:, then [Set] [Pick All] MAT = 2 REAL = 1 TYPE = “1 SHELL63” [OK] Or issue: AATT, 2, 1, 1 9A. Select LogicSilo 5. Select the areas of the upper part of the cone and assign the solid model attributes: Utility Menu Select Entities … Select “Areas”, “By Location”, “Z coordinates” Min,Max = -30,0 [Apply] [Replot] Main Menu Preprocessor MeshTool … Select “Areas” under Element Attributes:, then [Set] [Pick All] MAT = 1 REAL = 2 TYPE = “1 SHELL63” [OK] Or issue: ASEL,S,LOC,Z,-30,0 APLOT AATT, 1, 2, 1 9A. Select LogicSilo 6. Select the areas of the lower part of the cone and assign the solid model attributes: Utility Menu Sele