利用全矩阵的程序..docVIP

#includeg:\caa\liu\liu2.h void sortBranch(BRANCH *, int);//根据支路号对Branch数组排序 void Input();//电路数据结构输入 void vFoud();//确定电压定义支路的条数bv，并顺序编号； //同时建立一般支路编号bNUM和电压定义支路编号vbNUM之间的影射关系 void GotA();//采用改进节点法求得增广矩阵aMatrix; lpGaussFE();//Gauss前消算法 void bGaussBS();//Gauss后代算法 void main() { start: char aa; clrscr(); Input(); sortBranch(Branch, BranchNumber); vFoud(); GotA(); lpGaussFE(); bGaussBS(); cout\n\nDo you want to exit?(y/n):; cinaa; switch(aa){ case n: goto start; case y: break; } } //--------------------------------------------------------------------------- void Input() { char aa; cout\n R:1 G:2 VS:3 CS:4 VCCS:5 VCVS:6 CCCS:7 CCVS:8 OPAMP:9; cout\n\nPlease input the sum of branchs: b=; cinBranchNumber; coutPlease input the sum of nodes: n=; cinNodeNumber; Branch = new BRANCH[BranchNumber+1];//分配内存 coutPlease input the parameters of the branchs:; gotoxy(4,7);cout------------------------------------------------------------------; gotoxy(4,8);coutBRANCH; gotoxy(11,8);coutnumber; gotoxy(18,8);couttype; gotoxy(25,8);coutnfrom; gotoxy(33,8);coutnto; gotoxy(39,8);coutvalue; gotoxy(46,8);coutncfrom; gotoxy(54,8);coutncto; gotoxy(61,8);coutsure(y/n); gotoxy(4,9);cout------------------------------------------------------------------; int i=1; while(i=BranchNumber){ change: coutendl; gotoxy(5,9+i);cout[i]; gotoxy(13,9+i);cinBranch[i].number; gotoxy(20,9+i);cinBranch[i].type; gotoxy(27,9+i);cinBranch[i].nfrom; gotoxy(34,9+i);cinBranch[i].nto; gotoxy(41,9+i);cinBranch[i].value; /*if(Branch[i].type==1||Branch[i].type==2||Branch[i].type==3||Branch[i].type==4){ Branch[i].ncfrom=0;gotoxy(48,9+i);cout0;} else{*/ gotoxy(48,9+i);cinBranch[i].ncfrom;//} /*if(Branch[i].type==1||Branch[i].type==2||Branch[i].type==3||Branch[i].type==4||Branch[i].type==7||Branch[i].type==8){ Branch[i].ncto=0;gotoxy(55,9+i);cout0;}*/ //else{ gotoxy(55,9+i);cinBranch[i].ncto;//} again: gotoxy(65,9+i);cinaa; s