d c a c c l a m p m e t e r- amprobe（d c c c l m p m e t e r - amprobe）.docVIP

DGC-1000A CLAMP-ON GROUND RESISTANCE TESTER USERS MANUAL  EN 61010-2-032 CAT III 300V, CAT II 600V Pollution Degree 2 Definition of Symbols: Caution: Refer to Accompanying Documents Caution: Risk of Electric Shock Double Insulation Table of Contents I. WARNING 1 II. FEATURES DESCRIPTION 1 III. PANEL DESCRIPTION 2 IV. LCD DISPLAY 3 V. OPERATION INSTRUCTION 4 5-1. Ground Resistance Measurement 4 5-2. High and Low Alarm ( ) 7 5-3. Ground/Leakage Current Measurement 9 5-4. Setting the Sampling Interval 10 5-5. Data Logging 10 5-6. Read the Data Stored in Memory 11 5-7. Clear Data Memory 11 5-8. Cancel the Auto Power Off 11 VI. PRINCIPLE OF OPERATION 11 VII. ELECTRICAL SPECIFICATION 14 VIII. GENERAL SPECIFICATIONS 15 IX. BATTERY REPLACEMENT 16 I. WARNING 1. Use of rubber gloves is a good safety practice even if the equipment is properly operated and grounded. 2. Safety is the responsibility of the operator. 3. Use extreme caution when using the instrument around energized electrical equipment. 4. Do not attempt to use the ground tester to twist or pry the ground electrode or ground wire away from the equipment being grounded. 5. All metal objects or wires connected to an electrical system should be assumed to be lethal until tested. Grounding system is no exception. II. FEATURES DESCRIPTION The clamp-on ground resistance tester enables the users to measure ground resistance of a ground rod without the use of auxiliary ground rods. Clamp-on ground resistance tester is used in multi-grounded systems without disconnecting the ground under test. III. PANEL DESCRIPTION Jaws Assembly: Enclose electrode or ground rod. No air gap is allowed between two half jaws. Hold Button: Press this button to freeze the value in LCD Rotary Switch: Turn power on and select the desired function. 4. LCD REC button: When one of the functions is selected by FUNC button, it is used to increment value. If no function is selected, it