4- portal engineering information center（4 -门户工程信息中心）.docVIP

4.5 A beam of the cross section shown is extruded from aluminum alloy for which σy= 250 MPa and σu= 450 MPa. Using a factor of safety of 3.00, determine the largest couple that can be applied to the beam when it is bent about the z axis. 4.10 Two equal and opposite couples of magnitude M = 25 kN . m are applied to the channel-shaped beam AB. Observing that the couples cause the beam to bend in a horizontal plane, determine the stress at (a) point C, (b) point D, (c) point E.. 4.15 Knowing that for the extruded beam shown the allowable stress is 120MPa in tension and 150 MPa in compression, determine the largest couple M that can be applied. 4.20 Knowing that for the beam shown the allowable stress is 12 ksi in tension and 16 ksi in compression, determine the largest couple M that can be applied. 4.21 Knowing that σall=24 ksi for the steel strip AD, determine (a) the largest couple M that can be applied, (6) the corresponding radius of curvature. Use E=29 X 106 psi. 4.39 and 4.40 A steel bar (Es = 210 GPa) and an aluminum bar (Ea= 70 GPa) are bonded together to form the composite bar shown. Determine the maximum stressing (a) the aluminum, (b) the steel, when the bar is bent about a horizontal axis with M =60N.m. 4.49 A concrete beam is reinforced by three steel rods placed as shown. The modulus of elasticity is 3 x 106 psi for the concrete and 30 x 106 psi for the steel Using an allowable stress os 1350 psi for the concrete and 20 ksi for the steel, determine the largest allowable positive bending moment in the beam. 4.50 Knowing that the bending moment in the reinforced concrete beam is +150 kip.ft and that the modulus of elasticity is 3.75 x 106 psi for the concrete and 30 x 106 psi for the steel, determine (a) the stress in the steel, (b) the maximum stress in the concrete. 4.57 A steel pipe and an aluminum pipe are securely bonded together to form the composite beam shown. The modulus of elasticity is 210 GPa for the steel and 70