802.15.3channelplan-ieee-sa.docVIP

IEEE P802.15 Wireless Personal Area Networks Project IEEE P802.15 Working Group for Wireless Personal Area Networks (WPANs) Title TG3 PHY: 802.15.3 channel plan Date Submitted [02 July, 2001] Source [Chandra Vaidyanathan][Aryya Communications][444 N Frederick Av., Suite 309 Gaithersburg, MD 20877] Voice: [240-683-8802]Fax: [301-947-8964]E-mail: [chandrav @ieee.org ] Re: [] Abstract [This contribution proposes a channel plan for 802.15.3 WPAN.] Purpose [To propose a channel plan for 802.15.3 high-rate PHY.] Notice This document has been prepared to assist the IEEE P802.15. It is offered as a basis for discussion and is not binding on the contributing individual(s) or organization(s). The material in this document is subject to change in form and content after further study. The contributor(s) reserve(s) the right to add, amend or withdraw material contained herein. Release The contributor acknowledges and accepts that this contribution becomes the property of IEEE and may be made publicly available by P802.15.  Introduction This document proposes a channel placement scheme for the IEEE 802.15.3 WPAN system (see also 0169r2P802-15_TG3-Channel-plan-for-HR-WPAN). The WPAN system is designed to be compliant with FCC 15.249 (US), ETS 300 328 (Europe) and ARIB STD T66 (Japan). The WPAN PHY operates in the 2.4 – 2.4835 GHz frequency range and its transmit spectrum mask is shown in Figure 1. The channel placement is determined by finding the minimum and maximum center frequencies that meet the regulatory emission requirements. The middle channels are selected by maintaining channel spacing greater than 15 MHz to avoid spectral overlaps between adjacent channels. Figure 1: Transmit spectrum mask Regulatory requirements The relevant (near 2.4 – 2.4835 GHz) regulatory requirements are summarized below: ETS 300-328 The radiated power and peak power density should be less than or equal to 20 dBm and 10 dBm/MHz, respectively Wideband and spurious emissions outs