ospf接口认证.docVIP

OSPF接口认证 R1 配置 R1(config)#no ip domain-lookup R1(config)#line console 0 R1(config-line)#logging synchronous R1(config-line)#no exec-t R1(config-line)#exit R1(config)#interface s0/0 R1(config-if)#ip address 13.1.1.1 255.255.255.0 R1(config-if)#no shutdown R1(config-if)#exit R1(config)#do ping 13.1.1.3 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 13.1.1.3, timeout is 2 seconds: !!!!! Success rate is 100 percent (5/5), round-trip min/avg/max = 4/34/80 ms R1(config)#interface s0/1 R1(config-if)#ip address 12.1.1.1 255.25.255.0 R1(config-if)#no shutdown R1(config-if)#exit R1(config)#interface lo 0 R1(config-if)#ip address 1.1.1.1 255.255.255.0 R1(config-if)#exit R1(config)#end R1#ping 12.1.1.2 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 12.1.1.2, timeout is 2 seconds: !!!!! Success rate is 100 percent (5/5), round-trip min/avg/max = 4/31/52 ms R1(config)#router ospf 110 R1(config-router)#router-id 1.1.1.1 R1(config-router)#network 12.1.1.0 0.0.0.255 a 0 R1(config-router)#network 13.1.1.0 0.0.0.255 a 1 R1(config-router)#network 1.1.1.0 0.0.0.255 a 0 R1(config-router)#exit 明文认证 R1(config)#interface S0/1 R1(config-if)#IP ospf authentication R1(config-if)#ip ospf authentication-key ccna R1(config-if)#exit R1(config)#do show ip ospf *Mar 1 00:13:49.387: %OSPF-5-ADJCHG: Process 110, Nbr 2.2.2.2 on Serial0/1 from FULL to DOWN, Neighbor Down: Dead timer expired R1(config)#do show ip ospf nei Neighbor ID Pri State Dead Time Address Interface 3.3.3.3 0 FULL/ - 00:00:36 13.1.1.3 Serial0/0 R1(config)#end R1#debug ip ospf adj OSPF adjacency events debugging is on R1# *Mar 1 00:14:29.375: OSPF: Rcv pkt from 12.1.1.2, Serial0/1 : Mismatch Authentication type. Input packet specified type 0, we use type 1 R1# *Mar 1 00:15:09.411: OSPF: Rcv pkt from 12.1.1.2, Serial0/1 : Mismatch Authentication Key - Clear Text R1# *Mar 1 00:15:55.055: OSPF: 2 Way Communication to 2.2.2.2 on Se