C10-DSPBuilder设计初步范例.ppt

9.7 DSP Builder的状态机设计 * 9.7.2 状态机设计流程 【例9-1】 IF ((pop_sig=1) AND (conut_in_sig=0)) THEN next_state = empty_st； ELSIF (push_sig=1) THEN next_state = push_not_full_st ; ELSIF (pop_sig=1) AND (conut_in_sig / =0)) THEN next_state = pop_not_empty_st ; ELSIF (push_sig=1) AND (conut_in_sig =250)) THEN next_state = full_st ; ELSE next_state = idle_st ; END IF ; 9.7 DSP Builder的状态机设计 当前状 条件 次态 Idle (pop =1) (count_in = 0) empty Idle (push =1) (count_in=250) full Idle (pop =1) (count_in! = 0) pop_not_empty Idle push =1 push-_not_full * 表9-4 表9-3的改变 9.7.2 状态机设计流程 9.7 DSP Bu