连接器振动等测试参数供参习.docVIP

TERMINAL BLOCKS BJL Reliability Test BJL端子排 信赖性测试 FOREWORD This document is the property of Amphenol Pcd Shenzhen Co., Ltd. and cannot be used, reproduced, transmitted or disclosed without their prior authorization. Revision A6/2/96 Date/日期 01/06/2007 Issued Name/姓名 Thomas Huang 发布 Signature/签名 Date/日期 Checked Name/姓名 检查 Signature/签名 Date/日期 Approved Name/姓名 批准 Signature/签名 Note: Fundamental modifications, compared with the previous edition, are indicated by a vertical line in the right margin. MODIFICATIONS REVISION A DATE 01/06/2007 LOC. DESCRIPTION First Issue 1. SCOPE 适用范围 This Test Review contains test items and methods for FAST ON TYPE TERMINAL BLOCK(BJL) 此测试规范定义插入式接线端子排(BJL系列)的测试项目及测试方法 2. TEST ITEMS 测试项目 - Salt Spray 盐雾测试 - Damp heat 耐湿热性测试 - Rapid temperature variations 快速温度变化测试 - Torque force 扭力测试 - Withstanding voltage 耐压测试 - Temperature rise 温升测试 - Vibration 振动测试 3. TEST METHOD 测试方法 3.1 - Salt Spray (CNS、C6014、NFC93461§3.4.6): 盐雾测试 (按标准CNS\C6014\ NFC93461§3.4.6): Test requirements: 测试要求： Sample size: 4pcs at least 试样数：至少4pcs零件 Test time: 96 hours 测试时间：96小时 3）Temperature: 35±2℃ 测试温度：35±2℃ 4）Saline solution with a concentration of 5% NaCl in weight 盐溶液浓度为5%NaCl 5）PH value of saline solution: 6.5~7.2 盐溶液PH值在6.5~7.2间 6）Every 24 hours, please check the samples surface if there are changes, and record the result in the report 每24小时，观察样品的表面是否有变化，并记录在报告中 7）At the end of test, samples shall be rinsed 5 minutes with demineralized water and placed in oven at 100±2℃ during 1 hour minimum. Then they shall be exposed for 1 hour at room temperature 测试完后，样品用软化水清洗5分钟后，置于100±2℃烘箱中最小1小时，然后取出在室温下放置至少1小时 Sanction: 判定： There shall be no damage or fall off from plating surface of metallic parts tested 在测试后，金属镀层不得有损坏或脱落 3.2 - Damp heat (IEC 998-1-12/13、NFF 61017