磨擦磨损试验台的设计.docVIP

分类号 密级 UDC 学 位 论 文 作者姓名： 指导教师： 申请学位级别： 硕士 学科类别： 工学 学科专业名称： 机械电子工程 论文提交日期： 论文答辩日期： 学位授予日期： 答辩委员会主席： 评阅人： 东 北 大 学 A Dissertation in Mechanical and Electronic Engineering Research and of Fixture for Solenoid Valves’ Test System Northeastern University  独创性声明 本人声明，所呈交的学位论文是在导师的指导下完成的。论文中取得的研究成果除加以标注和致谢的地方外，不包含其他人己经发表或撰写过的研究成果，也不包括本人为获得其他学位而使用过的材料。与我一同工作的同志对本研究所做的任何贡献均己在论文中作了明确的说明并表示谢意。 学位论文作者签名： 日 期： 学位论文版权使用授权书 本学位论文作者和指导教师完全了解东北大学有关保留、使用学位论文的规定：即学校有权保留并向国家有关部门或机构送交论文的复印件和磁盘，允许论文被查阅和借阅。本人同意东北大学可以将学位论文的全部或部分内容编入有关数据库进行检索、交流。 （如作者和导师不同意网上交流，请在下方签名；否则视为同意。） 学位论文作者签名： 导师签名： 签字日期： 签字日期： 摘 要 Research and Development of Fixture for Solenoid Valves Test System Abstract Solenoid valve needs to be tested by hand for a long time. So the testing efficiency is low and it is prone to be affected by artificialness. Now, automation technology has been applied to more and more factories. The Solenoid Valve test system will also realize auto-test by computer in the future. The Solenoid Valve test system researched in this paper is developed for a company. It will realize auto-test, improve the efficiency in testing solenoid valve performance and make the testing data more precise than before. In order to realize auto-test in the system, it needs a fixture system which is exact and credible. This paper discusses a kind of fixture which can clamp all kinds of solenoid valves. The basic request is to finish clamping the tested valves before the test, and to assure that there’s no leakage during the test. At the same time, the fixture must be easy to manipulate and convenient to maintenance. The fixture designing is finished after researching the requirement of the valves’ test figure size and work parameter. In order to keep good airproof, the fixture not