TRT程序【DOC精选】.docVIP

1 STARTSTOP： 验*) TestRS( Set := Test_Set, R1 := Test_Reset or Stop_Reset, Q1 = Test_Status ); (*启动条件具备*) Start_Allow:=not PE511_L and not PE401_LL and not PI601_L and PSA413 and PSA303 and PSB303 and PdS524 and not Stop_Signal and PE301_H; (*透平申请启动*) StartApplyRS( Set := Start_Allow and Start_Apply, R1 := Stop_Signal or Start_Cancel, Q1 = PDC429 ); (*PDC438:=PDC429 and (SE801C_H or SE801A_H or SE801B_H);*) (*系统闭锁解除*) SystermReleaseRS( Set := PDC429 and Start_Allow and PdS567, R1 := Stop_Signal, Q1 = SystermInterlock_Release ); (*透平停机条件*) (*透平前轴振动A*) StopSignalRS1( Set := XT801A_HH, R1 := Stop_Reset, Q1 = StopSignal_Cond1 ); (*透平前轴振动B*) StopSignalRS16( Set := XT801B_HH, R1 := Stop_Reset, Q1 = StopSignal_Cond16 ); (*透平后轴振动A*) StopSignalRS17( Set := XT802A_HH, R1 := Stop_Reset, Q1 = StopSignal_Cond17 ); (*透平后轴振动B*) StopSignalRS18( Set := XT802B_HH, R1 := Stop_Reset, Q1 = StopSignal_Cond18 ); (*发电机前轴振动B*) StopSignalRS19( Set := XT803B_HH, R1 := Stop_Reset, Q1 = StopSignal_Cond20 ); (*发电机前轴振动A*) StopSignalRS2( Set := XT803A_HH , R1 := Stop_Reset, Q1 = StopSignal_Cond2 ); (*透平位移A*) StopSignalRS3( Set := ZT801A_HH OR ZT801A_LL, R1 := Stop_Reset, Q1 = StopSignal_Cond3 ); (*透平位移B*) StopSignalRS20( Set := ZT801B_HH OR ZT801B_LL, R1 := Stop_Reset, Q1 = StopSignal_Cond20 ); (*透平转速*) StopSignalRS4( Set := (SE801A_HH AND SE801B_HH) OR (SE801B_HH AND SE801C_HH) OR (SE801C_HH AND SE801A_HH), R1 := Stop_Reset, Q1 = StopSignal_Cond4 ); (*润