PB10酸度计标准操作规程中英文对照.pdfVIP

1.0 Purpose: 目的 1.1 建立 PB-10 酸度计的使用、维护与保养规程，确保测定数据的准确性。 For establish the use and maintenace on pH Meter PB-10 procedure, to ensure the accuracy of measurement data. 2.0 Scope：范围 2.1 适用于原料、辅料、中间产品、成品、水质以及缓冲溶液的pH值测定。 Apply to determine the pH value of raw materials, auxiliary materials, intermediate products and finished products, water quality and buffer solution. 3.0 Responsibility：职责 3.1 实验操作员 Laboratory technician 4.0 Definitions: 定义 4.1 pH值：pH值是衡量一种溶液酸度或碱度的尺度，用下面的公式表示： pH=-log[H+] [H+]表示溶液中氢离子的浓度，pH值有时也被称为“氢离子指数”。 pH: pH is a measure of the acidity or alkalinity of a solution and can be represented by this equation: pH=-log[H+] with [H+] representing the concentration of hydrogen ions in the solution. pH is sometimes referred to as the power of the hydrogen ion in a solution. 5.0 Procedure：规程 5.1 准备 Preparation 5.1.1将变压器插头与 pH计 Power（电源）接口相连，并接好交流电。 Connection power cable to meter power jack and to AC power source. 5.1.2 将 pH复合玻璃电极与 BNC（电极）和 ATC（温度探头）输入孔连接。 Connect a glass pH electrode to the input and ATC connectors. 5.1.3 按 Mode键设置 pH模式（pH，mV或相对 mV）。 Press Mode until the display indicates the appropriate measurement mode (pH or mV/relative mV ). 5.2 校正 Standardization 5.2.1按 SETUP键，显示屏显示 Clear，按 Enter键确认，清除之前的校准数据， 并选择您所需要的缓冲液组。 Press Setup and the meter displays a flashing Clear icon. Press Enter to clear all existing buffers and to select a new set of buffers. 5.2.2 将复合电极用蒸馏水清洗，滤纸吸干后浸入第一种缓冲液（6.86），充分 搅拌，按 Standardize键， pH计识别出缓冲液并将闪烁显示缓冲液值。达到稳 定状态后，或通过按 Enter键，测量值即已被保存；pH计显示电极斜率为 100%。 Rinse electrodes with distilled water and blot-dry, place electrodes in the first buffer solution (6.86), stir. Press Standardize, the meter recognizes the buffer and flashes a buffer icon. When the signal is stable, or when you press Enter, the buffer is entered. The meter displays the %slope of the electrode as 100%. 5.2.4将复合电极