Adsorption of dichloromethane from water onto a.pdfVIP

下载本文档

3
0
约4.38万字
约 13页
2017-04-06 发布于江苏
举报
版权申诉

Adsorption of dichloromethane from water onto a.pdf

1、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。。
2、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击这里二次下载。
3、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。
4、该文档为VIP文档，如果想要下载，成为VIP会员后，下载免费。
5、成为VIP后，下载本文档将扣除1次下载权益。下载后，不支持退款、换文档。如有疑问请联系我们。
6、成为VIP后，您将拥有八大权益，权益包括：VIP文档下载权益、阅读免打扰、文档格式转换、高级专利检索、专属身份标志、高级客服、多端互通、版权登记。
7、VIP文档为合作方或网友上传，每下载1次，网站将根据用户上传文档的质量评分、类型等，对文档贡献者给予高额补贴、流量扶持。如果你也想贡献VIP文档。上传文档

Adsorption of dichloromethane from water onto a

ARTICLE IN PRESS0043-1354/$ - se doi:10.1016/j.w Correspond fax: +8263 620 E-mail addrWater Research 39 (2005) 617–629 /locate/watresAdsorption of dichloromethane from water onto a hydrophobic polymer resin XAD-1600 Jae-Wook Leea,, Heung-Joe Junga, Dong-Heui Kwaka, Paul-Gene Chungb aFaculty of Environmental and Chemical Engineering, Seonam University, Namwon 590-170, Republic of Korea bFaculty of Environmental and Chemical Engineering, Chonbuk National University, Chonbuk 561-756, Republic of Korea Received 2 February 2004; received in revised form 17 June 2004; accepted 6 October 2004Abstract Dichloromethane is one of the chlorinated volatile organic compounds (CVOCs) that contaminate the waters. Especially, the dichloromethane used as a solvent in polycarbonate synthesis, is dissolved in wastewater with the saturated solubility of 17,220mgL1, which is several times that of other CVOCs. Thus, it is reasonable to recover the dichloromethane dissolved in water instead of destruction based on the economic point of view. To study on the recovery of the dichloromethane, adsorption equilibrium and column dynamics were investigated using a hydrophobic polymer resin (XAD-1600) without the ion-exchange functional groups. In addition, a hydrophilic polymer resin (XAD-7) and an activated carbon (DY-GAC) were chosen for comparison. Conventional two- or three-parameter models such as the Langmuir, Freundlich, or Sis equations could not fit the adsorption equilibrium data of two polymer resins obtained over the entire range of concentration (1–200molm3). They were well fitted by a hybrid model consisting of Langmuir and BET (Brunauer–Emmett–Teller) equations. The adsorption amount at high concentration was in the order of XAD-16004XAD-74DY-GAC on a mass basis. To confirm the possibility of using resin as a sorbent for the removal of dichloromethane, adsorption breakthrough curves were measured under key operating conditions such as the concentration, the flow rate, and the c