使用Commview For Wifi- Wpa Key Recovery (Wpakr)破解Wpa.pdfVIP

WPA Key Recovery Help Documentation Copyright ? 2007 TamoSoft About WPA Key Recovery WPA Key Recovery (WPAKR) is an add-on for CommView for WiFi designed to recover WPA passwords for WPA- or WPA2-protected 802.11 a/b/g wireless networks in Pre-Shared Key (PSK) mode. Because WPA/WPA2 encryption contains no known weaknesses, the recovery process is based on trying all passwords loaded from the dictionary file one by one, as well as optional password permutations. Installation Requirements To install WPAKR, simply launch the setup file. WPAKR requires CommView for WiFi 5.6 or later and will be installed to the CommView for WiFi application folder. You can also install WPAKR on a computer without CommView for WiFi if you would like to use WPAKR in offline mode, for processing capture files copied from the computer running CommView for WiFi. If you install WPAKR on a computer without CommView for WiFi, you can launch it by double-clicking the programs executable file located in the folder to which you installed it. If youd like to use a distributed recovery process, i.e. use multiple computers simultaneously, you will find the installation instructions in the Splitting the Job Between Multiple Computers chapter. Usage Once WPAKR has been installed, you can launch it by clicking Tools = WPA Key Recovery in the CommView for WiFi menu, as shown below: Note that this menu item becomes available only after youve installed WPAKR. When WPAKR is launched, CommView for WiFi establishes a TCP/IP connection with WPAKR so CommView for WiFi can send captured packets to WPAKR for analysis. To be able to recover a WPA-PSK key, WPAKR needs to receive packets with Association or Re-association Request followed by EAPOL key exchange packets. These are the packets used in WPA for negotiating session keys. Its important that all of the EAPOL key exchange packets and at least one Association or Re-association Request packe