化纤废水污水处理厂论文.docVIP

  • 25
  • 0
  • 约1.02万字
  • 约 18页
  • 2017-04-26 发布于河南
  • 举报
 PAGE \* MERGEFORMAT 18 (此文档为word格式,下载后您可任意编辑修改!) 毕 业 设 计 [论 文] 题 目:张家港化纤集团生产废水处理工程设计 学 院: 市政与环境工程学院 专 业: 环境工程 摘要 该化纤集团主要生产黏胶短纤维,废水产生量为500 m3 short fibers,its wastewater quantity is 500 m3 in it ,so the wastewater is physico chemical per-treatmented and then Oxidation ditch biochemical treatmented.The concentrations of Zn2+ 、COD、SS and oil are greatly reduced, effluent water meets the level 1 of emissions requirements in the integrated wastewater discharge standard (2002) GB18918 . Processing unit structures are projected, plane and elevation layout of processing station is also presented, meanwhile its economic is accounted. The wastewater is not only well degraded ,but also economically feasible, fulfill the sustainable development . Keywords: Chemical fiber wastewater, Physico chemical per-treatment,Oxidation ditch, Sulfide, Zn2+ 目 录  TOC \o 1-3 \h \z \u 摘要  PAGEREF _Toc359141476 \h II Abstract  PAGEREF _Toc359141477 \h III 前言  PAGEREF _Toc359141478 \h 1 1 设计原始资料  PAGEREF _Toc359141479 \h 2 1.1 设计进水水量、水质及排放标准  PAGEREF _Toc359141480 \h 2 1.2 水质特点分析  PAGEREF _Toc359141481 \h 2 2 污水处理工艺设计方案的分析和确定  PAGEREF _Toc359141482 \h 3 2.1 污水处理工艺设计方案的分析  PAGEREF _Toc359141483 \h 3 2.1.1 SS、石油类物质的去除  PAGEREF _Toc359141484 \h 3 2.1.2 硫化物、锌的去除  PAGEREF _Toc359141485 \h 3 2.1.3 COD的处理  PAGEREF _Toc359141486 \h 4 2.2 污水处理工艺设计方案的确定  PAGEREF _Toc359141487 \h 4 2.3污水处理工艺流程  PAGEREF _Toc359141488 \h 4 3 主要构筑物及工艺设计计算  PAGEREF _Toc359141489 \h 6 3.1 格栅的设计  PAGEREF _Toc359141490 \h 6 3.1.1 设计说明  PAGEREF _Toc359141491 \h 6 3.1.2酸水格栅的设计计算  PAGEREF _Toc359141492 \h 6 3.1.3碱水格栅的设计计算  PAGEREF _Toc359141493 \h 8 3.1.4格栅水力计算图  PAGEREF _Toc359141494 \h 10 3.2提升泵房  PAGEREF _Toc359141495 \h 11 3.2.1泵房的设计依据:  PAGEREF _Toc359141496 \h 11 3.2.2设计说明  PAGEREF _Toc359141497 \h 13 3.2.3设计计算  PAGEREF _Toc359141498 \h 13 3.3曝气沉砂池的设计  PAGEREF _Toc359141499 \h 14 3.3.1设计说明

文档评论(0)

1亿VIP精品文档

相关文档