functionmod_out=modulation(mod_in,mod_mode).docVIP

function mod_out=modulation(mod_in,mod_mode) %%************************************************************************* %%Function information: %%------------------------------------------------------------------------- %%First time : 3/25/2002 %%Newest modified time:6/20/2002 %%Programmer:Xuewei Mao %%Version: 0.2 %%------------------------------------------------------------------------- %%************************************************************************* %%************************************************************************* %% Reference: %%------------------------------------------------------------------------- %% %%------------------------------------------------------------------------- %% Note: %%------------------------------------------------------------------------- %% %%------------------------------------------------------------------------- %% Function discription: %%------------------------------------------------------------------------- %%根据输入的调制方式，对输入序列MOD_IN进行调制，分别采用BPSK, QPSK, !6QAM, 64QAM， %%完成对星座图的映射，输出为Y.转化的方法为：先写出十进制情况下从0 到N-1 %%（N为星座图的点数）所对应的星座坐标；再将输入的二进制序列转化为相应的 %%十进制，以查表的方法查出对应点的复数坐标，即为调制映射后的结果。 %%The OFDM subcarriers shall be modulated by using BPSK, QPSK, 16-QAM, or 64-QAM modulation, %%depending on the RATE requested. The encoded and interleaved binary serial input data shall %%be divided into groups of N BPSC (1, 2, 4, or 6) bits and converted into complex numbers %%representing BPSK, QPSK, 16-QAM, or 64-QAM constellation points. The conversion shall be %%performed according to Gray-coded constellation mappings, with the input bit MOD_IN. The %%output values,MOD_OUT are formed by multiplying the resulting (I+jQ) value by a normalization %%factor K MOD , as described in equation d = (I + jQ) × K MOD ) The normalization factor,K MOD, %%depends on the base modulation mode. Note that the modulation type can be different from the %%start to