招标师考试《招标采购案例分析》命题趋势权威试卷中大网校2.doc

2010年招标师考试《招标采购案例分析》命题趋势权威试卷(7) 总分：100分 及格：60分 考试时间：120分 本试卷均为案例分析题（共8题，每题12.5分），要求分析合理，结论正确；有计算要求的，应简要写出计算过程。 (1) (2) (3)A href=javascript:;/A (4)A href=javascript:;/AA href=javascript:;/A (5) (6)A href=javascript:;/A (7) (8)A href=javascript:;/A 答案和解析 本试卷均为案例分析题（共8题，每题12.5分），要求分析合理，结论正确；有计算要求的，应简要写出计算过程。 (1) : A /A(2) : A /A(3) : A /A(4) : A /A(5) : A /A(6) : A /A(7) : A /A(8) : A /A 中大网校引领成功职业人生 or equal to 200 mm, not more than 4 mm. 7.3.9 simmering bending production of square steel tube extension, to use the whole tube bending. Interface if necessary, the welding position should be located in the middle of the vertical arm. 7.3.10 install expansion joints should be done. If design is not required, pipe compensator lengthen should conform to the requirements in the following table: square scale length δ x is equal to 1/2. Pre stretch tolerance: casing + 5 mm, +10 mm. 7.3.11 pipe form, location, spacing shall meet the design and specifications. 7.3.12 piping on back or return pipe at higher levels of the upper to automatic valve to install a drain valve below the horizontal parts. 7.3.13 supports and hangers of checks and the number 1) hanger installed must be checked before installation of supports and hangers part models, specifications of springs setting values, whether the materials meet the requirements of drawings and documents; 2) supports and hangers of material, size and accuracy shall conform to the provisions of the design drawings, material technical requirements should be consistent with national standards, industry standards and technical requirements related to the alloy spectrum review should be carried out; 3) pipe supports and hangers part plant product quality certificate for each variable spring supports, constant support hangers, dampers, damper function, there should be factory calibrated test and performance test copies of the record. If necessary, review sho