Quickbuilder点参数modbus地址格式.docxVIP

Defining a Modbus Address for a Point Parameter给一个点参数规定一个Modbus地址Entering an Address访问一个地址For PV Source Address, Source Address, and Destination Address the format for an Modbus controller address is:一个Modbus控制器地址的PV源地址，源地址和目标地址格式是：ControllerName Location控制器名字位置Part 部分 Description描述ControllerName控制器名The name of the Modbus controller.Modbus控制器的名字Location 位置The address within the controller where the value is stored. See Location Syntax. 这个值储存在控制器里的位置。查看Location Syntax. If you would like help when defining an address, click next to Address to display Address Builder.当你规定地址的时候如果你希望得到帮助的话，点击下一步去处理建立地址的显示Using the Address Builder to Enter an Address用这个地址建立提示去建立地址To specify a Modbus controller address, specify the items as follows: 制定一个Modbus控制器地址，制定项目如下：Property 性能 Description 描述Address Type 地址类型 Select Controller.选择控制器Controller 控制器 Select the appropriate Modbus controller. 选择一个适当的Modbus控制器Location 位置The address within the controller where the value is stored. See Location Syntax. 这个值储存在控制器里的位置。查看Location Syntax.Location Syntax位置语法The format for the location is:位置格式是：Address [DataFormat|BitNumber] 地址[数据格式|字节数]Part 部分 Description 描述Address 地址The address (decimal) for the parameter value within the controller table.在控制器表格里参数值的地址If the address is prefixed with the table number, omit the table number. For example, the first register in table 4 is often written as 40001 or 400001. Enter 1 as the address. 如果位址与表数目一起前缀，省略表数目。例如，在表4里的第一个注册位置经常被写成40001或者400001.写1作为地址。The table number prefix is shown on the Scanning tab of the Point Detail display and when you use the commands listag, rtusum and lisscn. 前缀的桌面数被显示在点细节显示扫描界面当你用listag, rtusum和lisscn命令时DataFormat点格式 The data format acronym or starting bit number, depending on how you want the value to be read: 点格式的首字母缩写或者起始位数字，取决于你想用哪个值读取Data Format for Scaling 16-bit Integers 16位整形缩放比例的点格式Data Format for Reading Floating Point Values 浮点数的点格式Data Format for Reading Raw Values Without Scaling 没有缺陷的不成熟点的数据格式If you want to use