D624-00橡胶的热塑性弹性的耐老化性的抗撕裂强度的试验方法.pdfVIP

Designation: D 624 – 001 Standard Test Method for Tear Strength of Conventional Vulcanized Rubber and Thermoplastic Elastomers1 This standard is issued under the fixed designation D 624; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon () indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the Department of Defense. 1 NOTE—The table in Fig. 1 on DIE C was corrected editorially in March 2001. 1. Scope caused a cut, defect, or localized deformation. The following 1.1 This test method describes procedures for measuring a definitions define different techniques for measuring the resis- property of conventional vulcanized rubber and thermoplastic tance to tear, i.e. the tear strength, required for use with this elastomers called tear strength. standard. 1.2 The values stated in SI units are to be regarded as the 3.2 Definitions of Terms Specific to this Standard: standard. The values given in parentheses are for information 3.2.1 Type A tear strength—the maximum force required to only. cause a nick or cut in a Type A (nicked crescent) test piece to 1.3 This standard does not purport to address all of the grow by tearing the rubber, divided by the thickness of the test safety concerns, if any, associated wi