固溶处理对铸造Ti2．5Al1．5MoZr钛合金组织和性能的影响.pdfVIP

学兔兔 铸 造 Feb．2010 ·138· FOUNDRY VOI．59 No；2 固溶处理对铸造Ti2．5AI1．5MoZr钛合金组织和 性能的影响 谢华生1．2，娄延春 ，赵 军 ，刘时兵 ，汪志华 ，刘宏宇 ，史 昆 (1．沈阳铸造研究所，辽宁沈阳1 10022；2．沈阳工业大学，辽宁沈阳1 10023) 摘要：对铸造Ti2．5Al1．5MoZr钛合金在不同固溶温度、不同冷速条件下的显徽组织和力学性能进行了研究。结果表明： 在850～920℃范围内，随固溶温度的升高，该合金的显微组织逐步细化，短棒状初晶 相增加明显， 相间距增大，残 留B相和转变马氏体增加，强度增加，塑性降低；随固溶冷却速度的增加，组织中的魏氏体逐渐减少，网篮状组织明显 增加，初晶 相出现短棒化趋势，强度增加，塑性降低。 关键词：固溶；钛合金；显微组织；Ti2．5Al1．5MoZr；性能 中图分类号：TG146．2+3 文献标识码：A 文章编号：1001—4977(2010)02—0138—03 Effects of Solution Treatment on Microstructure and Mechanical Properties of Cast Ti2．5AI 1．5MoZr Alloy XIE Hua．sheng’一2’LOU Yan．chun1，ZHAO Jun1，LIU Shi．bing’，WANG Zhi．hua1，LIU Hong．yu1，SHl Kun1 (1．Shenyang Research Institute of Found~，Shenyang 1 1 0022，Liaoning，China； 2．Shenyang University of Technology，Shenyang 1 1 0023，Liaoning，China) Abstract：Microstructure and mechanicaI properties of cast Ti2．5Al 1．5MoZr alloy at different solution temperatures and different cooling rates were investigated．The results show that in the range of 850．920℃ ，with the increase of solution temperature，the microstructures of alloy were refined， quantity of short—rod primary oc phases increased obviously，and the space between a phases， quantity of residuaI 13 phases and martensite also increased．Those resulted in the increase of strength and decrease of plasticity of the alloy．With the increase of cooling rate after solution treatment，quantity of the Widmanstaten structure decreased gradually，and the network structure increased