模具的保养1.pptVIP

塑模保養維修講義mold maintenance handout 前述preface 適用範圍及責任單位suitable scope and responsibility unit 適用範圍: suitable scope: HPQ/內銷成型廠----塑膠模具. HPQ/inside market molding factory ----plastic mold 2. 責任單位: responsibility unit: 模修單位 toolmaker 成型加工單位 molding department 保養作業內容maintenance operation contents 日常保養時機 daily maintenance opportunity (定時保養和每班保養)(timely maintenance and every class maintenance) 1.定時保養模面清潔: Timely maintain mold surface 生產中之模具------每隔1小時一次. mold in production ------one time every 1 hour 2.每班保養: every class maintenance 生產中之模具------每班保養一次. mold in production------one time each class 細 部 保 養 時 機opportunity for details maintenance 1.工令結束 the end of work order 2.定時保養: timely maintenance: 大型外觀件模具----每隔四萬模次 large-sized mold ----every 40 thousands times PVC 模具----每隔二萬模次 PVC mold ----every 20 thousands times 其它模具----每隔五萬模次. other mold ----every 50 thousands times 常用保養工具maintenance tool in common use 模具保養的一般步驟steps of mold maintenance Separate mold 拆模 Clear up 清理 Lubricate 潤滑 Assembly 組立 Set to former position 歸位 日常保養主要內容main contents of daily maintenance 公,母模面及排 氣槽的清洗clean the surface of mold and air vent 1. 用氣槍吹乾凈公模面,母模面及排氣槽內的料屑. Clean the material trifles of mold surface and air vent by air gun. 2. 用沾去漬油的棉布擦拭乾淨公.母模面 Clean mold surface with the cotton cloth soaked eliminate spot oil. 1.用氣槍吹乾凈導套、頂針、滑塊等部位clean bush 、eject pine and sliding block etc. with air gun 3.給公模導柱、复位桿、頂針、滑塊等部位抹上一層潤滑油Add lubricant for guide post 、reset ram 、eject pine and sliding block of core 模具外表面的保養maintenance of mold’s outer surface 用噴槍吹模具表面上的粉塵,使其保乾凈 Blow the dust of mold surface by air gun and keep it clean 日常保養注意事項matters needing attention in daily maintenance 一. 保養前要注意確認: