双相合金Mg-8Li-1Al的等通道转角挤压Ⅰ.挤压过程中的变形方式.pdfVIP

第 39 卷第8 期 Vo l.39 No.8 合品专址 2003 年 8 月 790-一794 页 ACTA METALLURGICA SINICA Aug. 2003 pp.790-794 双相合金Mg一8Li-lAl 的等通道转角挤压* I 挤压过程中的变形方式 刘腾张伟吴世丁美传斌李守新徐永波 (中国科学院金廊研究所沈阳材料科学国家(联合)实验室.沈阳 110016) 摘 要 以 X 射线衍射分析术为主要分析孚段，探讨丁双相含金 Mg-8Li-1Al(1lf{量分数. %)在等通道传角挤压 (ECAP) 变形过程中的变形方式 。相在第 1 道次 ECAP 过程中主要的变形方式是 {lOïl} (ï012) 孪生生， 在随后道欢的 ECAP 过段 中主要变形方式为位错滑移.变形方式的转变主要是由于 ECAP 造成的组织细化效应§ 对于 β 相，各道次 ECAP 的主要变形 方式均为也错滑移 关键词 双相合金 Mg-8Li-1Al ，等逼迫转角挤压，孪生，位错滑移 中图法分类号 rG146.2 ,TG37 文献标识码 A 文擎编号 0412-1961(2003)08-0790-05 EQUAL CHANNEL ANGULAR PRESSING OF A TWO-PHASE ALLOY Mg-8Li一lAl 1. Deformation Modes During ECAP LIU Teng, ZHANG Weí, WU Shiding, JIANG Chl.lanbin, LI Shou:xin, XU Yongbo Shenyang N~tional Labor~tory {or M~terials Science, Institute o{ Metal Research , The Chinese Academy of Scien阳台， Shenyang 110016 Corr哩spondent: WU Shídíng, professor, Tel: (024)899782刀， E-mail: shdw.I.I @imr.ac.cn Su仰。付ed by National Natural Science Found a.tion of China. (NO.SOI7.1 02纱， National Key Bωic Resea.nh a.nd Development Prog ra.mme of China (No. Manuscript re伺ived 200:• 11-06, in revised form 2003-02- 27 ABSTRACT The deformation modes during the process of equal channel angular pressing (ECAP) of Mg-8Li- 1Al (mass fraction , %) alloy were discussed using the results of X- ray diffraction analyses. Through the analyses of the X-ray diffraction data and the corresponding crystallography, it was found that during the first pass of ECAP, the main deforma.tion mode ofαphase is {10I1}币。12) twinning , while during the following p硝ses the main deforma.tion mode is disloca.tion slip. T