PE弯头管件的挤出压缩工艺研究.pdfVIP

第 40 卷，第 9 期 Vo1.40 , No.9 36 工程塑料应用 2012 年9 月 ENGINEERlNG PLASTICS APPLICATION Sep. 2012 doi:l0.3969/j.issn.l001-3539.2012.09.009 件的挤出压缩工艺研究* PE 弯头 成升文 1 ， 2 ，梁业兴 1.z ，贺建平 1 ， ZJ马鑫江1.2 ，黄虹宾 1 ， 2 ( 1.深圳大学机电与控制工程学院，广东深圳 518060; 2. 深圳大学深圳市模具先进制造技术重点试验室，广东深圳 518060 ) 摘要:采用挤出压缩工艺制备了聚乙烯(PE) 弯头管件，对管件尺寸精度的影响因素进行了研究，着重探讨了模 腔温度、压缩时间与管件尺寸精度之间的关系。结果表明，当压缩压力为 25 MPa、熔体温度为 220C、定模内腔温度 为 60C、压缩时间为 12 min 时，利用挤出压缩工艺制备的 PE 弯头管件尺寸精度最高，且高于优化后的注塑工艺。 关键词:弯头管件;聚乙烯;挤出压缩;模具;尺寸精度 申图分类号: TQ320.66+2 文献标识码:A 文章编号: 1001-3539(2012)09-0036-04 Extrusion Compression Technology of PE Elbow Pipe 1 Cαhe阳len臼en吨l噶gShe览en鸣gwen 气. Liang Yi曰ex对imIn1g6l口.2飞， HeJ丑ima缸扭n叩1甲pμiIn鸣l噶gl.2气， Fen咆l咆g Xingj副i扭g扩1气 HuangHong曲bi叮旷n11.2 (1. Col1ege of Mechatronics and Control Engineering, Shenzhen University , Shenzhen 518060 , China; 2. Shenzhen Key Laboratory ofAdvanced Manufacturing Technology for Mold Die , Shenzhen 518060 , China) Abstract: Polyethylene (PE) elbow pipes were prepared by extrusion compression technology and the influence factors on dimension precision of the pipes were studied. The relationships between mold cavity temperature , compr巳ss time and dimension precision of the pipes were explored emphatically. The results showed that when compress pressure was 25 MPa , the melt temperature was 220C, mold cavity temperature was 60C, compress time was 12 min , the dimension precision ofPE elbow pipe prepared by extrusion compression technology was the highest and it was better than that of the pipe prepared by i叼ection molding process after optimization. Keywords: elbow pipe ; polyeth