郑州黄河公铁两用桥施工控制关键技术研究.pdfVIP

学兔兔 郑州黄河公铁两用桥施工控制关键技术研究 孙英杰，肖海珠，徐 伟 文章编号：1003—4722(20l1)02 0005—04 郑州黄河公铁两用桥施工控制关键技术研究 孙英杰，肖海珠，徐 伟 (中铁大桥勘测设计院有限公司，湖北 武汉 430056) 摘 要：郑州黄河公铁两用桥是斜边桁无竖杆的三主桁、单索面多塔斜拉桥，为了使该桥建成 后达到设计 目标受力状态，对其施工全过程进行控制，钢梁顶推过程中以最大悬臂状态关键杆件内 力控制为主、线形控制为辅；顶推到位后以预制桥面板抄垫高程和索力控制为重点。建立板梁索相 结合的空间模型模拟施工过程，根据计算结果确定施工I临时平联布设方案，并实现顶推过程平面中 线控制、顶推完成后墩顶3桁高差调整、桥面板高差控制、斜拉索张拉控制，确保各施工阶段的杆件 内力、斜拉索索力和主梁线形3项指标均达到设计要求。 关键词：公路铁路两用桥；斜拉桥；结合梁；桁架；顶推法架桥；施工控制 中图分类号：U448．121；U448．27；U445．1 文献标志码：A Research of Key Techniques for Construction Control of Zhengzhou Huanghe River Rail·‘cure‘·Road Bridge SUN ling—jie，XIAOHai—zhu，XUWei (China Railway Major Bridge Reconnaissance Design Institute Co．，Ltd．，Wuhan 430056，China) Abstract：Zhengzhou H uanghe River Rail—cum—Road Bridge is a single—cable-plane and multi— pylon cable——stayed bridge having three main trusses without vertical members and with two in—— clined side trusses．To ensure that the completed bridge of the bridge could meet the design target force conditions，the whole construction process of the bridge was controlled．In the process of incremental launching of the steel truss girder，the internal force in the critical members of the girder in the state of the maximum cantilever was controlled mainly while the geometric shape of the girder was controlled subsidiarily．Once the girder was launched in place，the precast deck slab leveling elevation and the cable forces of stay cables were the major points that would be par— ticularly controlled．The spatial models of the slab—girder—cable were set up tO simulate the con— struction process and in accordance with the calculation，the arrangement of temporary constr