金山铁路黄浦江特大桥施工监控.pdfVIP

学兔兔 桥梁建设 2012年第42卷第1期(总第211期) Bridge Construction，Vo1．42，No．1，2012(Totally No．211) 文章编号：1003—4722(2012)01—0113—05 金山铁路黄浦江特大桥施工监控 宋胜录 ，伍小平 ，李茂兴 (1．上海建工集团股份有限公司技术中心，上海200431；2．上海市基础工程有限公司，上海200433) 摘 要：上海金山铁路支线改造工程黄浦江特大桥为4x112 m下承式简支钢桁梁桥，主桥采 用悬臂拼装+辅助临时支架施工。该桥悬臂施工风险大，为确保施工安全，对主要构件施工过程中 的应力、位移、反力等参数进行监控。采用MIDAS Civil 2006软件建立空间模型，通过现场实测数 据与理论数据对比分析可知：施工过程中大部分测点的实测应力小于理论应力，满足安全要求；由 于节点板局部刚度影响，实际刚度较理论计算刚度大15 左右；在最大悬臂工况下，实测位移小于 理论位移，最大偏差达10 mm；所有支撑反力均控制在3 000 kN以内，保证了悬臂施工过程中临时 支撑的安全。 关键词：铁路桥；桁架桥；悬臂拼装架桥；应力；位移；反力；桥梁施工；施工监控 中图分类号：U448．211；U445．4 文献标志码：A Construction Monitoring and Control of Huangpu River Bridge on Jinshan Railway SONG Sheng—lu ，WU Xiao-ping ，LI Mao—xing (1．Technique Center，Shanghai Construction Group Co．，Ltd．，Shanghai 200431，China； 2．Shanghai Foundation Engineering Co．，Ltd．，Shanghai 200433，China) Abstract：Huangpu River Bridge of the Reconstruction Project of Jinshan Railway Branch Line in Shanghai is a simply—supported through steel truss girder bridge with span arrangement 4 ×1 1 2 m．The main bridge of the bridge was constructed by the cantilever assembling and erection by the aid of temporary supports．Because of risk of the cantilever construction and to ensure the construction safety，the stress，displacement and reaction forces of principal components of the bridge in the construction process were monitored and controlled．The software MIDAS Civil 2006 was used to set up the spatial models and it was found from the comparison and analysis of the f