ABS塑料外观性能一. 流纹(国外英文资料).docVIP

ABS塑料外观性能一. 流纹(国外英文资料) U? Mechanical properties and shapers One. Tensile strength and elastic modulus ? The four does not significantly affect the elastic modulus of forming parameters. The tensile strength is mainly affected by the directional, high strength plastic parts in the orientation direction. There is evidence that heating time has a harmful effect., as compared with the performance impact tensile properties are influenced by the place Zi within the lower magnitude. Figure 8 qualitatively expressed important performance response. Said, quantitatively in from the cold melt slowly fill to hot melt quickly filling in typical conditions. When the room temperature tensile yield strength can reduce the 5 to 10% of normal. [15] packing pressure and mold temperature had no obvious effect. Two. Bending strength and bending modulus These performance is the same as the response to the form parameter, so the above is fully available. Three.? creep Available finite data shows that the forming parameters have no obvious effect on creep. Four. Heat distortion temperature Research results show that the annealing and annealing heat distortion temperature on forming parameters of response of the material is slightly different. No annealing heat distortion temperature of the material affected by the filling pressure and mold temperature, melt temperature and filling rate are not found in have any impact. Trying to not refund the heat distortion temperature stress associated with directional or cooling efforts have failed. [11] is a well-known fact that interesting, annealing often will heat distortion temperature increase 400 f. literature [4] on the basis of molecular relaxation concept to explain the effects of forming parameters. Figure 9 shows that the filling pressure of high heat distortion temperature losses back 10 ~ 150 f [15]. Cold mould (800 f) can reduce not refund heat distortion temperature of 100 f [11]. High filling pressure and rapid cooling block elements