剪力墙钢筋工程量计算讲解_secret(国外英文资料).docVIP

剪力墙钢筋工程量计算讲解_secret(国外英文资料) Chapter 3 shear wall steel bar calculation When calculating the steel bar, the following questions should be considered: (figure 18) What kind of reinforcement does the shear wall need to calculate? The shear wall is mainly composed of walls, walls, beams and holes, including horizontal bars, vertical bars, tendons and holes. The wall column consists of two types: the dark column and the end column. The beams of the wall include two types of dark girders and even girders, which have a longitudinal and stirrup. Calculating the wall of shear wall should consider the following factors: basic type, middle layer and top-level structure; The effect of wall column and wall beam on the steel bar of the wall. (figure 18) One, the wall is vertical to the reinforcement computation The section of the steel bar and its name A formula to calculate instructions The appended drawings Basic plug (base plate) When the raft foundation is less than or equal to 2000mm: Insert foundation reinforcement length = base height - cover basic bottom bend out a + + + top surface exposed length and the upper steel bar connection (such as welding, the lap length 0) 04g101-3p45 wall The bending length a is the same as the frame note Figure 19 When the raft basics 2000mm: Insert foundation reinforcement length = base bending height / 2 - layer + base + out of foundation top surface exposed length + connected to the top bars (such as welding, the lap length 0) 04g101-3p45 wall is constructed two Figure 20 Foundation beam When base beams and foundation plate base: Base length = base height - protection layer + base bottom bend a + extend the top surface of the base surface plus the upper surface bar connection 04g101-3p32 wall vertical bar reinforced concrete structure Note: if the welding is applied, the length is 0 Figure 21 When the roof of the foundation is on the top of the base board: Base length = base height - protection layer + base bottom bend a + extend the top