建筑工程知识详解10.11.12(国外英文资料).docVIP

建筑工程知识详解10.11.12(国外英文资料) Technical requirements for the construction of underground water-resistant projects 2A312042 understand the technical requirements of underground water resistant engineering The general requirement of underground waterproof works The waterproof grade of underground works is divided into four levels. The underground water proof project must be carried out by the qualified professional waterproof construction team, the main construction personnel should hold The construction administrative department or its designated unit shall issue a certificate of practice qualification. Two, structure self-waterproof concrete The concrete of waterproof concrete should be used in pre-mixed commercial concrete, and the sand rate must be strictly controlled 35% ~ 45%. The foundation slab waterproof concrete should be poured continuously, no construction seam, and the outer shear wall and the backside of the foundation are set aside The plate 300mm wall and the ground concrete are also cast. When the structure of the basement is divided into sections, it will produce vertical concrete construction seams. It should be added to the 200 mm wide stop water plate, the thickness is 2mm, put in the construction seam before pouring concrete. 3, the basement coil is waterproof (1) construction of the ground floor waterproof layer The water rate at the primary level is not greater than 9 percent, and the base of the seam is more than 600 mm, and the two pieces of coil are long No less than 100mm, the short edge is not less than 150mm, the upper and lower two layers should not be placed vertically. The C20 fine stone concrete protection layer, which is 50mm thick on top of the waterproof coil, after being checked and qualified. Facade permanent protection wall waterproof wipe 1:2. 5 cement mortar, protection layer 15 ~ 20mm thick. (2) the laying of the walls The length of the coil is not less than 100mm, the short edge is not less than 150mm, the upper and lower seam sh