流量开关(国外英文资料).docVIP

流量开关(国外英文资料) FS - T type heat flow switch the thermal conductivity of the inverter is designed on the basis of the principle of heat exchange, probe the built-in heating module as well as the thermal module, flow indicator of heat conduction and the flow velocity is closely related to the body, there is no medium flow, if the pipe thermal module receives the heat is a fixed value, and when the fluid flows through the flow indicator probe, the thermal module receives heat changes over medium velocity, thermal module and then the temperature signal into electrical signal, the processor to convert them into 4 ~ 20 ma electrical signals or flow and setting the corresponding contact signal output. Thermal conductivity flow indicator will flow sensor and the signal processor integration integration, the six LED indicator provides the trend of the flow state, according to the switching action value can simple under the protection of screws on the front panel of the potentiometer to adjust, and transistors, relay and analog output forms are available. The Gems piston type flow switch works the inside of a fluid channel in the shell that contains a piston with a permanent magnet inside. When the piston is flow caused by pressure differential drive, magnetic piston will make seal reed switch action inside the equipment (available for SPST and SPDT seal reed, it related to the product model). The diameter of the piston determines the starting flow. The stainless steel spring pushes the piston back when the flow is reduced. When the reed switch is turned on, the alarm or instruction can be transmitted far away. Or you can integrate it in automatic control In the system. Working principle: Thermal conductivity of thermal conductivity meter flow indicator is designed based on the heat transfer principle, probe the built-in heating module as well as the thermal module, heat flow indicator and the lateral fluid flow are closely related. If there is no medium flow pipe, thermal modu