010_砌加气砼砌块墙(国外英文资料).docVIP

010_砌加气砼砌块墙(国外英文资料) And minimize secondary reshipment. According to the size of the wall and the size of the block, arrange the layout of the building block to reduce the amount of cutting of the site as much as possible. According to the thickness of the block and the clearance height of the structure and the dimensions of the doors and Windows, the layout of the facade and section should be arranged effectively, so as to avoid waste. (3) the part of the build by laying bricks or stones aerated concrete block wall in structure on basis of + 1000 mm elevation lines hierarchical block layer, arranged mortar joint thickness of horizontal mortar joint 12-15 mm, the vertical mortar joint 15-18 mm. In the corresponding area, play the wall of the wall of the wall of the wall of the wall, and then play the facade of the reinforced concrete wall on the structural wall column. Post window position. (4) the floor MATS should be completed before the masonry, and the root of the gas wall shall be made up of three solid bricks (the height of the kick), or the concrete guide wall. (5) the interior wall on both sides of the gate can be pouring into the reinforced concrete small pillar, as the borders, exterior wall spacing by the regulation is put at the same time in the masonry concrete precast block (embedded wood brick), used for the fixed frame. (6) the day before the wall, the area of the reinforced concrete wall should be wet with the structure of the structure to ensure that the masonry is solid. (7) in case of a wall pipe, the position and size shall be checked in advance. To set aside for the main, reduce the aftershave and damage the wall. (8) according to the design requirement, preside at the structure wall column every 0. 5, 5, 5. 4. The operation process Technological process: The base processing, the building block and the door window connecting the block and the door window, the block and the floor connection (1) the primary treatment: to clean the bricks or concr