料仓挡墙设计(国外英文资料).docVIP

料仓挡墙设计(国外英文资料) Material cantilever retaining wall design Profile 1. The structure of the material of this project is the cantilever type retaining wall, the 4th level building, the wall high 6.5 m, buried deep 0.5 m. It is located on the right bank of the rostron hydropower station, which is responsible for the temporary storage of NO1 and NO2. The bottom of the bunker is set up as a feeding channel. Its size is as follows: Size of the retaining wall 2. The design basis Major design specifications and reference materials 1) design specifications for water workers retaining walls (SL379-2007); 2) the design specification of hydraulic concrete structure (sl191-2008); 3) the design specification for hydraulic building load (dl5077-1997); 2.2 geologic condition 2.3 design parameters 1) a cantilever retaining wall of reinforced concrete structure, the structure and strength calculation using the following data, soil pressure load of 1.2, set up the drain, according to the project characteristic, not considering water pressure. 2) the foundation allows bearing capacity [R] = 500kN/m2; The basis friction coefficient is equal to 0.4; After packing for gravel stone wall, internal friction Angle is 33.5 °, heavy 16.5 kN/m3; The anti-slip stability coefficient is greater than or equal to 1.2; The antidumping stability coefficient is greater than or equal to 1.5. 3) the concrete adopts C20, and the indexes are as follows: Fc = 9.6 MPa; ft = 1.10 MPa; The steel bar USES HRB335, and the intensity indicators are as follows: Fy = 300 mpa. Calculate the stability of the barrier wall 3.1 earth pressure calculation Based on the imaginary wall: Rupture Angle of 1:31.6 °, judge whether there is the second failure surface, calculated the second failure surface is found: rupture Angle 2 = 17.7 °. Ea = 290.63 kN/m, Ex = 180.42 kN/m, Ey = 227.84 kN/m, use a height of Zy = 2.65 m. The area of the wall is 11.48 m2, weight = 189.47 kN/m, and the center of gravity is 2.26 m The earth weight on