混凝土塌落度(国外英文资料).docVIP

混凝土塌落度(国外英文资料) Slump (Slump) is mainly refers to the plasticizing properties of concrete and pump performance, is to use a quantitative indicators to measure the extent (plasticizing and pump performance) of high and low, construction is used to judge it on the rails. Gradation change were the major influencing concrete slump, water content, weighing of transverse deviation, the dosage of admixture, are easy to be ignored and the temperature of the cement. The degree of slump refers to the ease of concrete, which is specifically to ensure the normal operation of the construction, including the water retention, liquidity and cohesion of the concrete. It is that concrete mixers are easy to operate (mixing, transporting, pouring and compacting), and they can obtain the quality and the concrete properties of concrete. It is a comprehensive technical property, including water retention, liquidity and cohesion. The main factors of influence and ease are the water usage, the ratio of water ash ratio, the ratio of sand, including the variety of cement, aggregate condition, time and temperature, admixture and so on. The test method Slump test method: use a fluently under 100 mm, 200 mm and 300 mm high trumpet-shaped slump barrels, pumping concrete after tamping, and then pull up barrels, because the damage phenomenon, the weight of concrete with high barrels (300 mm) minus the fall behind concrete peak height, referred to as the slump. If the difference is 10mm, the collapse is 10. Concrete slump, should according to the content of structural section of the building, steel, transport distance, pouring method, the mode of transportation, the vibrating decision ability and climate conditions, should be considered in selected mixture, and appropriate USES smaller slump. According to slump, concrete mixture can be divided into big liquidity concrete, slump 150 mm), liquidity concrete, slump of 100 ~ 150 mm), plastic concrete, slump 50 ~ 90), low plastic concrete (slump 10 ~ 40