中兴89系列交换机开通维护手册(国外英文资料).docVIP

中兴89系列交换机开通维护手册(国外英文资料) Zte 89 series switches to open maintenance manual: Set the device name The hostname FDDX_Zhongxingjifang_8905 Set the remote login user name and password The username zxr10 password zxr10 Username zxr10 password zxr10 privilege 15 / / set user zxr10, password zxr10 level 15 (maximum permissions) Setting limits remote login The line Telnet access - class 1 The acl standard number 1 Rule 1 permit 61.128.170.0.0.7 Rule 2 permit 218.70.65.232 0.0.0.0 Rule 3 permit 61.128.177.34 0.0.0.0 Rule 4 permit 222.179.186.188 0.0.0 Rule 5 permit 10.130.131.177 0.0.0.0 Rule 6 permit 222.179.235.222 0.0.0.0 Configure a standard acl to allow the address to be accessed and then reference the acl Set port single-port loop detection function Loop - detect reopen - time 10 / / set the port to open (in points) to port (device detection loop will automatic shutdown port) Loop - detect interface gei_2/1-24 enable / / open single-port loop detection capability on port (support batch) Configuration of the device STP protocol: Spanning - tree enable Spanning - tree the MST configuration The name zteInstance 1 vlan 1-4093 / / configure the vlan that needs to be protected. Note that the control vlan of zesr loop cannot be protected. Note: open the STP agreement we require in the global mode, and then enter the port mode, turn off the spanning tree protocol, in order to avoid the STP shocks caused by unstable network. Enter interface mode: Spanning - tree disable Equipment port speed limit: 89 series of equipment supports two-layer and three-layer speed limits, and we recommend that you try to limit speed as much as possible. Configuration in interface mode: Traffic - limit rate - limit 100000 buckets - size 4094 in Traffic - limit rate - limit 100000 buckets - size 4094 out 7 device configuration polymerization of port 89 series port aggregation support has three modes: active, on, we usually recommend the use of passive on (static mode), if you are using a dynamic way, t