土方工程量计算说明(国外英文资料).docVIP

土方工程量计算说明(国外英文资料) The calculation of the quantity of earthwork The classification of soil and rocks is seen in the soil and rock in the calculation rules of this chapter. List. The soil project is based on dry earth, and the division of dry and wet earth is based on geological survey data When the water rate is greater than 25%, it is wet. When the earth is wet, the coefficient is 1.18; When the machine is excavated, artificial, mechanical Times the coefficient 1.15. The division of the geotechnical project related projects: 1. The earthwork : flat ground level ground refers to the thickness of the in situ within plus or minus 30 ㎝ digging and filling and leveling; Beyond the The range of soil and stone is calculated by excavated soil and stone. Earth: digging thickness above 30 ㎝, in 3 m in width. The bottom and the bottom area in more than 20 ㎡ The earth was dug for the earth. Groove: the bottom width of the trough is within 3m, and the groove is raised in the groove by three times the width of the groove. The bottom of the pit: area within 20 ㎡ digging to dig a pit. Six, artificial earth stone square The depth of the excavated soil, trenching and excavation is the deepest of 6m, more than half of the earth The square measure is multiplied by a factor of 1.25. More than half of the amount of work is measured at the vertical depth of 1 meter per meter when the mud is excavated and the sand is deeper than 1.5 m Measured in meters, the depth is calculated from the bottom to the ground. When excavating the soil under the support of the retaining board, the volume of the earth is excavated by the factor of 1.43. When excavated the soil between the piles, the actual volume of the soil (excluding the volume of the pile) shall be manually multiplied by the system The number 1.50. When the site is excavated, filled in, and the earth is turned on, it is no longer possible to calculate the amount of flat field work. The backfill is suitable for the backfilling and ramming of