脱硫运转中石膏含水量大的启事剖析(国外英文资料).docVIP

脱硫运行中石膏含水量大的原因分析(国外英文资料) The gypsum has increased water content. The vacuum belt machine is the important equipment for the secondary dehydration of gypsum, and the effect of dehydration is related to the quality of the slurry and the cleanliness of the filter cloth. Vapor liquid separator of meter directly reflects the vacuum of belt conveyor, vacuum vacuum belt conveyor and gypsum moisture content show regular change, higher vacuum belt machine, reflects the pressure drop through the filter cloth when the filter water increases, reflects the gypsum moisture content increased. Increases its reasons, one is the dewatering equipment is not normal operation, such as filter cloth wash not clean, or the long cycle of filter cloth used will make the belt conveyor dehydration effect becomes poor, poor dehydration; Second, gypsum slurry itself of the nature of change, such as grout medium and small particles gypsum crystals increased or impurity content in slurry to cause filter cloth filter channel such as increased congestion, make the water in the slurry is not easy to separate from the pores of the filter cloth. If you want to achieve a certain solid-liquid separation effect, you must raise the vacuum. 2, the solution 2.1, pay attention to control the absorption tower in slurry density, such as density meter doubt is not accurate, can consult slurry circulating pump is normal when the current value, can also be artificial manual measurement, attention must be kept and the provisions of the density reached before start the gypsum discharge pump. Keep the PH between 5.0 and 5.5 to prevent high or low. Too low can cause desulfurization efficiency to decrease, corrosiveness strengthens, the amount of limestone that is not reflected in the high serum fluid is increased, the two kinds of situation is adverse to the operation stability. To strengthen wastewater discharge, control the absorption of the contents of the contents of the tcl-content below 10000ppm. It is necessar