江苏移动小区合并实施指导.pptVIP

2012-08-13 小区合并实施指导 江苏移动小区合并实施指导 Prepared By: Zhaoguang Sun 小区合并 小区合并典型应用(1) 市区街道覆盖，解决高楼遮挡问题 小区合并典型应用(2) 微潮汐话务覆盖，更有效地利用基站资源 小区合并典型应用(3) 高铁覆盖，减少切换，减少掉话 RRUS连接方式 RRUS的级联连接如图所示，其中直接与DUG相连的RRUS为主RRU（MRU），其他为扩展RRU（ERRU） 软件需求 OMT： R47B BTS SW： G12A_3（B1307R067C） BSC SW： R12/G12A IPA3 MCA01 OMT配置 除DBB配置外，其他与正常基站配置相同 OMT配置－DBB 在DBB的配置中根据连接方式不同选择不同的DBB结构： 级联连接： DBB 10_21 星形连接： DBB 10_02 OMT配置－Radio Overview MCTR相关参数 RXMOP:MO=RXOMCTR-7-0; RADIO X-CEIVER ADMINISTRATION MANAGED OBJECT DATA MO MAXPWR MAXTRX PAO TXMPWR IPM RXOMCTR-7-0 48 4 OFF MANUAL OFF RXMOP:MO=RXOTRX-7-0; RADIO X-CEIVER ADMINISTRATION MANAGED OBJECT DATA MO CELL CHGR TEI SIG MCTRI DCP1 SC RXOTRX-7-0 41110A 0 0 UNCONC 0 178 SWVERREPL SWVERDLD SWVERACT DCP2 DEFAULT B1307R066H B1307R066H 179 MCTR相关参数 IPM is a parameter set per MCTR MO to activate and deactivate the temporary power override functionality, to better utilize the MCPA power. Default value is OFF. MAXPWR is a parameter set per MCTR MO to define the maximum allowed mean power used by the MCPA, corresponding to a certain HW activation code. This parameter can be set with one decimal from G12A and on. The default value is 43.0 dBm. MAXTRX is a parameter set per MCTR MO to define the maximum number of TRXs possible to connect to the MCPA, corresponding to the same amount of HW activation codes for GSM TRXs. The value range is 0-16, but not all values are applicable for all MCPA HW variants, The default value is 0. MCTRI is a parameter set per TRXC MO to map the TRX to a specific MCPA.Applicable values are 0-15 and UNDEF (which means that the TRX is not connected to any MCPA). Default value is UNDEF MPWR is a parameter set per TX MO to limit the maximum cell power (BSPWRB/BSPWRT) that may be used for this TX. Appli