TS题库(国外英文资料).docVIP

TS题库 ISO/TS 16949: the knowledge bank of 2002 Part 1: choosing the topic 1, (A) should be consistent with the standard of the workplace. B) the requirement of the other workshop Severity 2 is an assessment of the following situations: (C) A) the frequency of potential failure modes B) detection of potential failure mode C) the impact of potential failure modes D) the risk order number RPN Description of the cause of failure which is appropriate (A) A) sealing ring is installed on top B) operator error Equipment failure D) not directed by the job The basis of the PFMEA is: (A) Process flow chart B) risk assessment C) control plan Bar chart The scope of the LPA audit is (D) A) all the processes B) the product C) personnel D) identify process and process steps D) required The product quality standard is passed (B) to the production line to operate the staff A) control plan B) the SOS/JIS Process drawing D) PFMEA The PCR report is a comprehensive statement of all relevant facts about a problem, which helps us to illustrate the root cause of the problem (E) and the problem. A) time B) place C) the definition of the problem D) the scope of the problem E) After completing the PCR report, the responsible person shall be signed and approved by the relevant authorities at all levels. The area of approval of the selected manufacturing area or the section of the section of the section of the department under the jurisdiction of the department. A) lead B) the original responsibility department C) the new responsibility department D) department All short-term solutions must be in the form of a responsible person, a break point information, and a current short-term measure. The deadline must be completed within (B). A) 12 hours B) 24 hours C) 48 hours D) 72 hours All long-term solutions must be carried out by the responsible person, the breakpoint information, and the state of the present measures. The term must be completed in (C). The important part of long-term measures is the