Chinasec平台装置卸载教程(国外英语资料).doc

Chinasec平台安装卸载教程 Chinasec trusted network authentication system Chinasec platform installation and uninstall Environmental preparation Install the console server Confirm server and console installation successfully Install the client Confirm client installation success Uninstall the client server console Environmental preparation 2 PC One installation Server and console, Server, one installation Client, Client Windows 2000 \ XP \ 2003 operating system. The hard disk space is at least 40G. Server at least two free USB ports and close all firewalls. When the console can connect to the server, use the administrator token login console, all of the following test procedures Both execute at the console and implement the policy. Each change policy needs to be right on the console root node and select apply all the system data Install the console server 1) run on the Server console installation file Setup_Z_MMC. Exe, follow the instructions the installation wizard. Now in the select installation components interface to select install FT99 token support + console file (default), as shown in the figure below: 2) enter the server IP address (native IP) when the server IP address Settings interface pops up. After installation, restart the computer. 4) run the server installation file setup_z_svr.exe on the Host -s. 5) close all the firewalls (including the Windows built-in firewall and third-party firewall); 6) when prompted to restart, you can choose whether or not to restart when the console is installed. Note: it is recommended to install the console first and then install the server. Because if the installation server first, then install the console, when install the console will be prompted to a file conflict, click on ignore until the installation is complete; The file conflict is as follows: 4 The attached: The cause of the conflict: first install the server program, run immediately after the installation of the server program, the installation of a console application