zstack网络的建立.doc

1. void ZDApp_Init( byte task_id ) { uint8 capabilities; // Save the task ID ZDAppTaskID = task_id; //设置任务id // Initialize the ZDO global device short address storage ZDAppNwkAddr.addrMode = Addr16Bit; ZDAppNwkAddr.addr.shortAddr = INVALID_NODE_ADDR; (void)NLME_GetExtAddr(); // Load the saveExtAddr pointer. //函数的作用是返回指向64bitIEEE地址的指针，但这里有点奇怪，它好像没有接收这个指针 // Check for manual Hold Auto Start ZDAppCheckForHoldKey(); //该函数的作用是如果HAL_KEY_SW_1键被按下，则not started automatically，如果不是自启动，则在自己的应用程序中要添加函数ZDOInitDevice( 0 )来启动建网过程，见Sample例子的应用程序 // Initialize ZDO items and setup the device - type of device to create. ZDO_Init(); // Register the endpoint description with the AF // This task doesnt have a Simple description, but we still need // to register the endpoint. afRegister( (endPointDesc_t *)ZDApp_epDesc ); //注册端点 #if defined( ZDO_USERDESC_RESPONSE ) ZDApp_InitUserDesc(); #endif // ZDO_USERDESC_RESPONSE // set broadcast address mask to support broadcast filtering NLME_GetRequest(nwkCapabilityInfo, 0, capabilities); //This function allows the next higher layer to get the value of a NIB (network information base) attribute NLME_SetBroadcastFilter( capabilities ); //This function sets a bit mask based on the capabilities of the device. It will be used to process valid broadcast addresses // Start the device? if ( devState != DEV_HOLD ) { ZDOInitDevice( 0 ); } else { // Blink LED to indicate HOLD_START HalLedBlink ( HAL_LED_4, 0, 50, 500 ); } ZDApp_RegisterCBs(); } /* ZDO_Init() */ 2. void ZDApp_RegisterCBs( void ) { #if defined ( ZDO_IEEEADDR_REQUEST ) || defined ( REFLECTOR ) ZDO_RegisterForZDOMsg( ZDAppTaskID, IEEE_addr_rsp ); #endif #if defined ( ZDO_NWKADDR_REQUEST ) || defined ( REFLECTOR ) ZDO_RegisterForZDOMsg( ZDAppTaskID, NWK_addr_rsp ); #endif #if defined ( ZDO_COORDINATOR ) ZDO_RegisterForZDOMsg( ZDAppTaskID, Bind_rsp ); ZDO_RegisterForZDOMsg( ZDAppTaskID, Unbind_rsp ); ZDO_RegisterForZD