分块模型的翻制步调和方法(国外英语资料).doc

分块模型的翻制步骤和方法(国外英语资料) 1, how to block: block die, also known as living mold, is a hard material in the sculpture on the basis of the shape of the ups and downs of the groove reasonable block, both can be separated, and can be assembled plaster model. A block can be more like manufacturing gypsum block, high on the requirements of the model, beginners can start from other simple point head block do exercises, with the accumulated experience and skills, can skillfully master the method of block mode. Block mode can choose a chieftain plaster head as seeds, the first analysis of the body structure. And imagine the overall to be divided into many blocks, between the module and the module to take a bite tenon, which, after take which are grading should consider the good, can make. Beginners can use a pencil lightly block line in plaster head, look at reasonable or not. Block molding exercises should be based on the shape of the gypsum block structure to a reasonable block, to do this, we must understand the main points for the block. (1) block module ranging from less can big is big, and can take up and not to bite, but not damaged the original. (2) the dividing line of the module shall be located at the high point of the body and the turning point of the body, so that the module is easy to make and the die taking is also convenient. (3) each division of a module, we should think of the surrounding several models between, how to do tenon, so that block and block between each other, both consistent and firm, coupled with a set of die binding, the block will not loose. 2, modular production methods: mold has a high degree of technical, the system must be patient, and to do while pondering, in order to effectively improve the quality of the model. Before turning over, use a stronger soap, water, plaster, head, brush over, as an isolation layer, after the dry can be practiced. Block mode in general from the following above began to do, then do on both sides, finally to deal