数字万用表使用方法1(国外英文资料).docVIP

数字万用表使用方法1(国外英文资料) The multimeter is measured in dc One, make mechanical zero. Choose the proper schedule. Three, make Rong multimeter block measuring current, should use a table in the series circuit in a quilt test, because only the string of current through the ammeter connected to milk to make the same as the branch current being measured. When measuring, it should be cut off by the measured branch, and the red and black pen string is connected to the quilt. Special attention should be paid to the fact that the current transcribing can be connected to the angiometer circuit, which is dangerous and can easily burn the meter. Notice the polarity of the measurement. Use scale and read correctly. Six, when the user access dc current of 2.5 A block, multimeter red pens and should be inserted in A measuring 2.5 jack, range switch can be placed on all range of dc current block. If the current of the quilt is greater than 2.5 A, the 2.5 A block will be extended to 5A. The method is simple, and users can plug in A 0.24 ohm resistor between the 2.5 A jack and the black jack, so that the stop becomes A 5A current. A resistance of 0.24 A should be chosen for the resistance of A line over 2W If the power is too small, it will burn down. The use of ohm 1, choose the right ratio. When measuring resistance in ohm gauge, the appropriate ratio should be chosen to make the pointer near the median. It is better not to use the third part of the scale on the left, which is very poorly calibrated. Zero before use. Three, can not electric charge measure. Four, the measuring resistance cannot have parallel branch. The polarity of two pens must be noted when measuring the equivalent resistance of the polar elements such as transistors and electrolytic capacitors. When the equivalent resistance of the non-linear element is measured by the different multirate ohm, the resistance value is different. This is due to the difference between the median resistance and the full amount of current i