话说电容之一：电容的作用(国外英文资料).docVIP

话说电容之一：电容的作用(国外英文资料) As a capacitance of one of the passive components, the function is not as follows: Apply to power circuit, realize the function of bypass, de-lotus, filter and storage. The following categories are detailed: 1) bypass The by-pass capacitance is the energy storage device for the local device, which can homogenize the output of the regulator. Lower load requirements. Like a small rechargeable battery, the bypass capacitor can be charged and moved into the device The discharge line. In order to minimize the impedance, the by-pass capacitor should be as close to the power supply and the ground of the load device as possible Pin. This is a good way to prevent the input value from being too large and causing the ground potential to rise and noise. To play is even The voltage drop of the current through the big current. 2) decoupled The lotus root, also called the lotus root. In the case of a circuit, it is always possible to distinguish between a driven source and a driven load. If the load capacitance is large, the driver circuit will charge and discharge the capacitor to complete the jump of the signal. When the rise is steep, the current is larger, and the current that drives is absorbed by a large amount of power Current, due to the inductance in the circuit, the resistance (especially the inductance on the chips foot), this A current is actually a noise relative to normal, and it affects the normal work of the previous level, which is the case Its called coupling. It is a battery that can be used to satisfy the change of the driving current and avoid the phase Intercoupling interference. It will be easier to understand the combination of the by-pass capacitors and the capacitors. The by-pass capacitor is actually also to the lotus root, but the by-pass capacitor is generally referred to as the high frequency bypass, which is to increase the low impedance to the high frequency switch noise Drain the way. High frequency bypass capacitors are genera