FANUC_系统部分参数功能目录（国外英文资料）.doc

FANUC_系统部分参数功能目录（国外英文资料） The FANUC system partial parameter function directory (0 - T or 0-0 in the M column indicates that the nc machine tool has this function, otherwise it will not have the subfunction.) Table 1? SETTING parameters Parameters of the no. symbol meaning 0 - T 0 - M 0000 PWE Parameters of the writing 0 0 0000 TVON Code vertical check 0 0 0000 The ISO The EIA/ISO code 0 0 0000 INCH MDI mode public/English system 0 0 0000 The I/O The RS - 232 c 0 0 0000 SEQ Automatic sequence number 0 0 ? Table 2?? RS232C mouth parameters 2/0 STP2 Channel zero stop bit 0 0 552 ? Channel 0 baud rate 0 0 12/0 STP2 Channel 1 stop bit 0 0 553 ? Channel 1 baud rate 0 0 50/0 STP2 Channel 2 stop bits 0 0 250 ? Channel 2 baud rate 0 0 51/0 STP2 Channel 3 stop bit 0 0 251 ? Channel 3 baud rate 0 0 55/3 RS42 Remote Buffer RS232/522 0 0 390/7 NODC3 The buffer is full 0 0 ? Table 3?? Servo control shaft parameters 1/0 SCW Male/British screw 0 0 3/0.1.2.4 ZM Back to zero direction 0 0 8/2.3.4 Now adws Name of the shaft ? 0 30/0.4 Now adws Name of the shaft 0 ? 32/2.3 LIN, 3, 4 axis, back axis/straight axis 0 ? 388/1 ROAX Turn back the axis of rotation function 0 ? 388/2 RODRC Absolute instruction is turning at close range 0 ? 388/3 ROCNT Relative instruction rule 0 ? 788 ? Turn the Angle of rotation 0 ? 1 1/2 ADLN Axis 4. Axis/axis ? 0 398/1 ROAX The return axis loop function ? 0 398/2 RODRC Absolute instruction is turning at close range ? 0 398/3 ROCNT Relative instruction rule ? 0 788 ? Turn the Angle of rotation 0 ? 860 ? Turn the Angle of rotation ? ? ? ? ? 0 0 500-503 INPX, YZ, 4 In width 0 0 504-507 SERRX, Y, Z, 4 The limit of the error in motion 0 0 508-511 GRDSX, Y, Z, 4 Raster displacement 0 0 512-515 LPGIN Position servo gain 0 0 517 LPGIN Location servo gain (shaft gain) 0 0 518-521 RPDFX, Y, X, 4 G00 speed 0 0 522-525 LINTX, Y, Z, 4 Line plus/deceleration time constant 0 ? 526 THRDT G92 time constant 0 ? 528 THKFL The lowest velocity of the G92X axis 0 0 527 FEDMX F t