RFID读卡程序（国外英文资料）.doc

RFID读卡程序（国外英文资料） Label: no label The RFID card read program The RFID card read program Keywords: 125k, reading card program, RFID A, principle 1, the hardware principle How hardware works Description reader: base station; Transponder: non-contact ID card. We use the MCU (microcontroller) is at89s52 devices (CS - Ⅲ board). Base stations in the electric power transmission frequency sine wave of 125 k by coupled inductor, the coupling coil ID card under the stimulus of 125 k sine wave induced electromotive force, it supplies power to the ID card. ID card through the modulation circuit according to the card class also sends out a sine wave, the ID card of the coupling coil base stations receive the coupling coil, according to its different with 125 k wave to different data. And it outputs it in the form of the manchestercode through the DATA end. The terminal of the base station NC (unused) The ACC (+ 5 v) GND (ground) DATA (DATA) GND (power management) Port of station connection Note: ACC + 5v power GND: ground terminal DATA: the DATA end is usually received by an external interrupt to receive the manchestercode by jumping GND: power management. High level: no power supply to base stations; Low level: allows power to be supplied to base stations Data encoding Data encoding is the representation of data as a special form of signal for reliable transmission of data. Digital signal coding technology The most common and easiest method for transmitting digital signals is to represent two binary values using two different voltage values. Zero voltage (or negative voltage), and positive voltage is 1. The commonly used digital signal codes are encoded by NRZ, Manchester, and Differential Manchester. 2.1.1, NRZ coding The advantage of this is that a single unit of code (a string of pulses) is the brightness of a unit pulse, which is called the full bright code. According to the communication theory, each pulse intensity, the greater the energy of signals, the greater the anti-i