三洋电磁炉工作原理说明（国外英文资料）.doc

三洋电磁炉工作原理说明（国外英文资料） Technical specification of IC 14FZ / 16FZ / 16FZC / 18FZ / 16YZ / 18YZ (original) One, electrical specifications Rated voltage: 220V / 50Hz; 2, the range of voltage adjustment: 198V ~ 242V; Rating: 1400 ~ 1800W; Power range: 320 ~ 1800W; 5, fixed temperature step: heat preservation, 140 ℃, 160 ℃, 180 ℃, 240 ℃; (plus or minus 20 ℃) Power division: 320W, 690W, 1080W, 1280W, 1340W. (+ 100 w) For 1400 w (for example) Standby power: less than 8W. Second, the ability to adapt to the environment 1, the temperature of 25 + 10 ℃ Humidity: 45 ~ 75%. Keyboard and indicator setting Keyboard: 5 key - open/close key 1, heat/heat key 1, ? Key 1, ? Key 1, time key 1. LED indicator lamp: heat insulation 1, heat 1, open/close 1; Heat preservation in heating/insulation 1, 140 ℃ 1, 160 ℃ 1, 180 ℃ 1, 240 ℃, 1, 1 10 in the timing, 20 1, 30 1, 60 minutes 1, a total of 12. Control panel: Consists of IC6 # 8, # 9, obtains the signal comparison on both ends of the wire disc L102, if has put the pot, IC6 # 9 oscillation waveform will shrink, the relative IC6 # 14, LO cycle will be narrowed, on the other hand, if there is no pot, LO of IC6 # 14 cycle will be broad, the waveform to IC1 # 1 for judging whether the LOAD (LOAD). When IC1 # 1 determine LOAD LOAD, HEAT DIS output LO PAN indicator, said it was heated, on the contrary, if the judge without LOAD when the LOAD, PAN, light is not bright, stop heating. 13 Over Voltage Protect Circuit When high voltage IGBT C, exceeds a certain value, via the IC6 # 13 output LO, forcing C302 via R324 discharge rapidly, to disrupt IC6 # 2 output, IGBT OFF, to protect IGBT damage due to C voltage is too high 4, function: 1, heating/insulation selection; 5 power optional for heating; The five temperature is optional when the temperature is fixed. 4, time 4 time optional; Test of pot quality: less than 8cm in diameter and heated in diameter larger than 12cm. 6, overheating protection: pan temperature exceeds 240 ℃ + 20 ℃, stop heating, the